Test date | Expiry date | Result | Odometer reading |
2017-01-11 | 2018-01-10 | ✓ Pass | 131,634 |
2017-01-07 | - | ✗ Fail | 131,599 |
- Battery insecure (1.9.1)
- Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
- Front Lower Suspension arm has excessive play in a pin/bush wishbone rear bush (2.4.G.2)
- Electrical wiring damaged, likely to cause a short live wire from battery (1.9.2b)
|
2017-01-04 | - | ✗ Fail | 131,482 |
- exhaust modified/noisy/repairs
- suspension lowered,rear coil springs binding
- idle co,hydrocarbons,lambda,all eratic/on limit
- n/s handbrake low effort
- o/s/f hub/rack/top mount play
- rear indicators faded
- aftermarket air filter fitted
- wiper blades insecure in holders,battery insecure
- n/s/f tyre ON limit/bald
- o/s/f wishbone rear bush play
- front bumper poor security/grounded
- Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)
- Nearside Headlamp aim too high (1.8)
- Parking brake: efficiency below requirements (3.7.B.7)
|
2016-12-15 | - | ✗ Fail | 131,150 |
- Rear Child Seat fitted not allowing full inspection of adult belt ()
- engine mgt lamp on!
- front bumper damaged
- rear indicators faded
- all round springs lowered
- exhaust blowing
- Nearside Front Steering rack play
- parking brake efficiency only just met!
- Horn not working (1.6.2a)
- Nearside Front Headlamp aim too high (1.8)
- Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)
- Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)
|
2015-12-16 | 2016-12-15 | ✓ Pass | 117,421 |
- Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)
- Offside Rear Direction indicator slightly discoloured (1.4.A.2f)
- engine noise
- oil leak
- Exhaust noisy (7.1.4)
- Centre Exhaust has a minor leak of exhaust gases (7.1.2)
- Offside Front play in rack
- Front bump damage
- emission on limit
|
2014-12-12 | 2015-12-11 | ✓ Pass | 106,254 |
- Offside Rear Direction indicator slightly discoloured (1.4.A.2f)
- Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
- Exhaust noisy (7.1.4)
- wipres under sized
- Oil leak
- lowering spring, air filter fitted
|
2014-12-06 | - | ✗ Fail | 106,241 |
- Offside Rear Direction indicator slightly discoloured (1.4.A.2f)
- Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
- Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
- wipres under sized
- Oil leak
- lowering spring, air filter fitted
- Front Exhaust has a major leak of exhaust gases (7.1.2)
- Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)
- Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)
- front brake excessively fluctuating (3.7.B.3)
- front brake application uneven (3.7.B.2)
|
2013-12-06 | 2014-12-05 | ✓ Pass | 88,242 |
- Exhaust noisy (7.1.4)
- bonnet has spacers fitted
- Oil leak
- lowering suspension springs fitted
|
2013-12-04 | - | ✗ Fail | 88,237 |
- Exhaust noisy (7.1.4)
- bonnet has spacers fitted
- Oil leak
- lowering suspension springs fitted
- Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)
- Exhaust has a major leak of exhaust gases (7.1.2)
- Nearside Inner Track rod end ball joint has excessive play (2.2.B.1f)
- Offside Inner Track rod end ball joint has excessive play (2.2.B.1f)
|
2012-12-03 | 2013-12-02 | ✓ Pass | 73,124 |
2012-12-03 | - | ✗ Fail | 73,124 |
- Front position lamp(s) slightly discoloured (1.1.A.3e)
- Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
- Inner Rear Tyre worn close to the legal limit (4.1.E.1)
- rear exhuast pipe fitted poorly
- Nearside Outer Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)
- Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)
|
2011-11-29 | 2012-11-28 | ✓ Pass | 60,625 |
- Exhaust noisy (7.1.4)
- Steering rack damaged but serviceable (2.2.C.1d)
- different size wheels & tyres front to rear
|
2011-11-29 | - | ✗ Fail | 60,625 |
- Exhaust noisy (7.1.4)
- Steering rack damaged but serviceable (2.2.C.1d)
- different size wheels & tyres front to rear
- Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)
|
2011-11-28 | - | ✗ Fail | 60,614 |
- Nearside Steering arm has relative movement at its fixings (2.2.B.1h)
- Offside Steering arm has relative movement at its fixings (2.2.B.1h)
- Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)
- Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)
- Nearside front brake juddering severely (3.7.A.2b)
- Offside front brake juddering severely (3.7.A.2b)
|
2010-11-19 | 2011-11-18 | ✓ Pass | 52,129 |
- Offside Front Tyre worn close to the legal limit (4.1.E.1)
- Exhaust noisy (7.1.4)
|
2009-10-28 | 2010-10-27 | ✓ Pass | 40,338 |
- Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
- Non obligatory mirror damaged
|
2009-10-28 | - | ✗ Fail | 40,338 |
- Non obligatory mirror damaged
- Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)
- Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)
- Front Brake pad(s) less than 1.5 mm thick (3.5.1g)
- Parking brake lever has no reserve travel (3.1.6b)
- Parking brake: efficiency below requirements (3.7.B.7)
|
2008-10-27 | 2009-10-26 | ✓ Pass | 26,899 |
2008-10-24 | - | ✗ Fail | 26,899 |
- Front Windscreen washer provides insufficient washer liquid (8.2.3)
- Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
- Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
|