Registration plate CA02WGD
Official local mnemonic: Cymru (Wales)
Postal area: Cardiff
Issued: between march 2002 and august 2002
White Citroen Relay, manufactured in 2002, first registered on 1 July 2002. Cylinder capacity: 2446cc.
As of 7 March 2017 this vehicle had done 91,909 miles. Current estimated odometer reading: 104,300 miles.
✗ Untaxed Tax due: 1 February 2019
✗ No MOT Expired: 17 March 2018

MOT history

Test dateExpiry dateResultOdometer reading
2017-03-072018-03-17✓ Pass91,909
2016-03-182017-03-17✓ Pass90,424
  • Brake actuating linkage mounting prescribed area is corroded but not considered excessive (3.3.A.2)
2015-07-15-✗ Fail90,187
  • Offside Front Upper Brake hose slightly deteriorated (3.6.B.4d)
  • Nearside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)
  • Offside Front Macpherson strut corroded but not seriously weakened (2.4.G.1)
  • Nearside Front coil spring corroded (2.4.C.1b)
  • Nearside Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)
  • Offside Rear Leaf spring anchor bracket corroded but not seriously weakened (2.4.B.6d)
  • The brake pedal rubber is worn
  • The nearside sill is ditorted
  • The offside rear sill is excessively corroded but outside prescribed area
  • The exhaust system is deteriorated and slightly blowing
  • 1 x exhaust rubber mount snapped and other mounts are perished but the exhaust is still being held secure
  • Advanced corrosion in the tipper body
  • Front park brake cable is corroded
  • The nearside chassis leg situated behind the front subframe is excessively corroded but outside the prescribed area
  • The nearside and offside front inner arch is coroded at the rear but outside the prescribed area
  • All four wheel bearings have slight play
  • The front jacking points have advanced corrosion
  • The nearside front chassis leg has advanced corrosion
  • The offside front chassis leg has advanced corrosion
  • The fuel tank has advanced corrosion
  • The chassis cross member next tothe brake compincating vale is excessivelt corroded but the brakevalve is still held secure on the chassis leg
  • There is corrosion throughout the rear chassis
  • The spare wheel cage is corroded
  • The rear most chassis cross member has advanced corrosion but not effecting suspension or brake components
  • Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
  • Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)
  • Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)
  • Offside Front Lower Brake hose excessively deteriorated (3.6.B.4d)
  • Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)
  • Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)
2014-07-082015-07-29✓ Pass83,969
  • Nearside Inner Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Inner Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Nearside Inner Front Lower Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Front Front wheel bearing has slight play (2.5.A.3c)
  • Nearside Front Brake hose slightly chafed (3.6.B.4d)
  • Offside Front Brake hose slightly deteriorated (3.6.B.4d)
  • Nearside Front Seat belt anchorage prescribed area is distorted but not considered excessive (5.2.6)
  • Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)
  • Offside Front Shock absorber has a slightly worn bush (2.7.4)
  • Offside Front Shock absorber has a light misting of oil (2.7.3)
  • Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • anti slip provision on brake pedal worn
  • washers in poor condition
  • towing socket in poor condition
  • offside rear mud guard damaged
  • offside front wheel arch liner damaged
  • exhaust system corroded and mountings in poor condition
  • rear chassis corroded throught
  • tipper bodt has advance corrosion and holed
  • Play in steering rack inner joint(s)
  • advance corrosion at rear brake valve but not insecure
2014-06-30-✗ Fail85,868
  • Nearside Inner Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Inner Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Nearside Inner Front Lower Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Front Front wheel bearing has slight play (2.5.A.3c)
  • Nearside Front Brake hose slightly chafed (3.6.B.4d)
  • Offside Front Brake hose slightly deteriorated (3.6.B.4d)
  • Nearside Front Seat belt anchorage prescribed area is distorted but not considered excessive (5.2.6)
  • Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)
  • Offside Front Shock absorber has a slightly worn bush (2.7.4)
  • Offside Front Shock absorber has a light misting of oil (2.7.3)
  • Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • anti slip provision on brake pedal worn
  • washers in poor condition
  • towing socket in poor condition
  • offside rear mud guard damaged
  • offside front wheel arch liner damaged
  • exhaust system corroded and mountings in poor condition
  • rear chassis corroded throught
  • tipper bodt has advance corrosion and holed
  • Play in steering rack inner joint(s)
  • advance corrosion at rear brake valve but not insecure
  • Offside Inner Front Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)
2013-07-092014-07-29✓ Pass78,589
  • Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • The brake pedal rubber is worn
  • The exhaust system is corroded throughout
  • The nearside front sill is distorted slightly
  • Slight corrosion on both front inner wheel arches
  • Slight corrosion throughout the chassis and tipper body
  • There is advanced corrsion around the rear brake compincator valve but the valve is held secure
2013-07-08-✗ Fail78,589
  • Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • The brake pedal rubber is worn
  • The exhaust system is corroded throughout
  • The nearside front sill is distorted slightly
  • Slight corrosion on both front inner wheel arches
  • Slight corrosion throughout the chassis and tipper body
  • Front Windscreen wiper does not clear the windscreen effectively (8.2.2)
  • Front Windscreen washer provides insufficient washer liquid (8.2.3)
  • Offside Rear Shock absorber has a serious fluid leak (2.7.3)
  • Front Brake pipe excessively corroded (3.6.B.2c)
  • Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)
2012-07-042013-07-29✓ Pass69,734
  • Brake pipe slightly corroded (3.6.B.2c)
  • Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • The nearside rear tyre is slightly perished
  • The tipper box sections are coroded
  • The centre exhaust box is corroded
2011-07-122012-07-29✓ Pass62,442
  • Offside Front wheel bearing has slight play (2.5.A.3c)
  • Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Brake pipe slightly corroded (3.6.B.2c)
  • Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Centre Exhaust has part of the system slightly deteriorated (7.1.1a)
2010-07-222011-07-29✓ Pass56,169
  • Nearside Inner Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Inner Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
2009-07-142010-07-29✓ Pass49,684
  • Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
  • Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)
2008-06-302009-07-29✓ Pass43,692
2007-07-112008-07-29✓ Pass37,963
2007-07-11-✗ Fail37,963
  • Offside Registration plate lamp not working (1.1.5c)
2006-07-132007-07-29✓ Pass30,511
2005-07-142006-07-29✓ Pass21,229
2005-07-14-✗ Fail21,229
  • Nearside Rear Shock absorber detached (2.7.2b)
  • Offside Rear Shock absorber detached (2.7.2b)

Comments

No comments.

Add comment

Attaching movies and photos (?)
It's enough to include link to photo or youtube or facebook movie into comment's content in order to attach them to the comment
Select files
You agree that you accept our rules

Worst drivers in April

  1. BP10 RVF
  2. LC06 OPH
  3. LL73 PZW
  4. YJ67 XKL
  5. PE14 YNZ
  6. W14 YUP
  7. GF58 NXE
  8. MC21 DVV
  9. MW13 MYU
  10. SA11 YKD

View drivers' rankings from previous months »

Do you like us?
or transfer some Bitcoins to 1L9Sd6UhYrugmYzp8Zv4iQtZoLRLdvWHPV